HLG-150h tumọ si ibi-agbara agbara imulo agbara
Apejuwe Awọn ọja
Mabomire 150W kuro ni ipese agbara iyọ , Awoṣe atẹle ni opolopo pẹlu awọn atupa han , HLG -152 H - 12 , HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15 , HLG - 15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG-15, HLG- 15
HLG-150 h -12 òfo: IP67 ti won. Okun fun i / o asopọ.
HLG-150 H -12a: IP65 ti a ṣe. Folti ti o jade ati ipele ti o wa lọwọlọwọ le tunṣe nipasẹ awọn iṣesi inu.
HLG-150 H -12: IP67 ti a ṣelọpọ. Ipele ti o wa lọwọlọwọ Ipele nipasẹ okun ti o pọju pẹlu 1 ~ 10VDC tabi ifihan ifihan PWM tabi resistance.
HLG-150 H -12D (aṣayan): IP67 ti a ṣelọpọ. Iṣẹ fifọ akoko, ifọwọkan tumọ si daradara fun awọn alaye.
|
Model
|
HLG-150H-12
|
HLG-150H-15
|
HLG-150H-24
|
|
Output
|
DC VOLTAGE
|
12V
|
15V
|
24V
|
|
CURRENT ADJ. RANGE
|
Can be adjusted by internal potentiometer A type only
|
|
7.5-12.5A
|
6-10A
|
3.8-6.3A
|
|
RATED POWER
|
150W
|
150W
|
151.2W
|
|
VOLTAGE ADJ. RANGE
|
10.8-13.5V
|
13.5-17V
|
22-27V
|
|
Input
|
Voltage Range
|
90-264VAC 127-370V DC
|
|
Frequency Range
|
47-63Hz
|
|
POWER FACTOR
|
PF>0.98/115VAC, PF>0.95/230VAC, at full load (Please refer to "Power Factor Characteristic" curve)
|
|
Efficiency(Typ.)(230Vac)
|
92%
|
92.5%
|
93.5%
|
|
AC CURRENT (Typ.)
|
1.7A / 115VAC 0.75A / 230VAC
|
|
INRUSH CURRENT(Typ.)
|
COLD START 75A/230VAC
|
|
LEAKAGE CURRENT
|
<0.75mA / 240VAC
|
|
PROTECTION
|
OVER LOAD
|
95~ 108%
|
|
Protection type : Constant current limiting, recovers automatically after fault condition is removed
|
|
SHORT CIRCUIT
|
Constant current limiting, recovers automatically after fault condition is removed
|
|
OVER VOLTAGE
|
14-17V
|
18-21V
|
28-34V
|
|
Protection type :Shut down O/P voltage, re-power on to recover
|
|
OVER TEMPERATURE
|
100 ℃ up or less10 ℃ (RTH2)
|
|
Protection type : Shut down and latch off o/p voltage, recovers automatically after temperature goes down
|
|
Environment
|
WORKING TEMP.
|
-40 ~ +70 ℃(Refer to output load derating curve)
|
|
WORKING HUMIDITY
|
20 ~ 95% RH non-condensing
|
|
SAFETY
|
SAFETY STANDARDS
|
UL8750, CSA C22.2 No. 250.0-08, EN61347-1, EN61347-2-13 independent IP65 or IP67, J61347-1, J61347-2-13 approved ;
design refer to UL60950-1, TUV EN60950-1
|
|
WITHSTAND VOLTAGE
|
I/P-O/P:3.75KVAC I/P-FG:2KVAC O/P-FG:0.5KVAC
|
|
ISOLATION RESISTANCE
|
I/P-O/P, I/P-FG, O/P-FG:100M Ohms/500VDC / 25 / 70% RH
|
|
EMC EMISSION
|
Compliance to EN55015, EN55022 (CISPR22) Class B, EN61000-3-2 Class C ( 50% load) ; EN61000-3-3
|
|
EMC IMMUNITY
|
Compliance to EN61000-4-2,3,4,5,6,8,11, EN61547, EN55024, light industry level (surge 4KV), criteria A
|
|
Others
|
MTBF
|
192.2K hrs min. MIL-HDBK-217F (25℃ )
|
|
DIMENSION
|
228*68*38.8mm (L*W*H)
|
|
PACKING
|
1.15Kg; 12pcs/14.8Kg/0.8CUFT
|
|
Note
|
1. All parameters NOT specially mentioned are measured at 230VAC input, rated load and 25 of ambient temperature.
2. Ripple & noise are measured at 20MHz of bandwidth by using a 12" twisted pair-wire terminated with a 0.1uf & 47uf parallel capacitor.
3. Tolerance : includes set up tolerance, line regulation and load regulation.
4. Derating may be needed under low input voltages. Please check the static characteristics for more details.
5. Type A only.
6. Safety and EMC design refer to EN60598-1, CNS15233, GB7000.1, FCC part18.
7. Length of set up time is measured at cold first start. Turning ON/OFF the power supply may lead to increase of the set up time.
8. The power supply is considered as a component that will be operated in combination with final equipment. Since EMC performance will be affected by the complete installation, the final equipment manufacturers must re-qualify EMC Directive on the complete installation again.
9. Refer to warranty statement.
|
1. Gbogbo awọn paramita ko mẹnuba ni pataki ti wọn ti wọn ni titẹ sii 230Vac, fifuye ti o ga ati 25 ti otutu otutu. Akiyesi
2. Ariwo ati ariwo jẹ wiwọn ni 20mhz ti bandwidth nipa lilo bata mẹrin kan ti o fopin si ti a fopin si pẹlu 0.1UF & 47UF Cpardal kan.
3. Ipari: Ninu ifikunri ti ṣeto, ilana ati ilana ẹru.
4. Isanwo le nilo labẹ folti titẹ sii kekere. Jọwọ ṣayẹwo awọn abuda sẹṣa fun awọn alaye diẹ sii.
5. Tẹ nikan.
6. Aabo ati apẹrẹ EMC tọka si En60598-1, CNS1523, GB7000.1, FCC ADC18.
7. Ipari Ti ṣeto akoko ti wa ni iwọn ni ibẹrẹ tutu akọkọ. Titan-an / pa ipese agbara le ja si ilosoke akoko ṣeto.
8. Ipese agbara ni a gba bi paati ti yoo ṣiṣẹ ni apapo pẹlu ohun elo ikẹhin. Niwon EMC iṣẹ yoo ni ipa nipasẹ awọn Fifi sori pipe, awọn aṣelọpọ ohun elo ikẹhin gbọdọ tun ṣe atunto Itọsọna EMC lori fifi sori ẹrọ pipe lẹẹkansi.
9. Tọkasi alaye atilẹyin ọja.
AKIYESI: Awọn atupa atọwọdọwọ ti o mu, Waher Odi, Wẹ Imọlẹ Warther, Ring Walds, Awọn imọlẹ ikunra, LED ita gbangba, Ina ti o wa ni isalẹ, awọn imọlẹ ọgba, awọn imọlẹ ti o wa labẹ omi kekere, ina kekere DMX Awọn Imọlẹ DMX, POW LED Pixel tube 360, tube Imọlẹ, LED tube, awọn solusan ina mọnamọna , mabomif youbbe tube, ina igi ina, dari Pẹpẹ , DJ Bal igi, DJ LED BARL BARL, Bawo ni Lati Fi ọpa ina LED, L Ed Ina Awọ Imọlẹ Imọlẹ, Starville Lena, Ile American LED BAR, Awọn apẹrẹ LED BAR, Imọlẹ Imọlẹ, Disitifu Imọlẹ, Imọlẹ 3D, 3D LED tube, Imọlẹ fidio LED Light, Did Ball, 3D LED rogodo, orillu boolu, DED rogodo ina ina, mu ki o gbe bọọlu ina ere, ktedball, awọn boolu kmx, DMX Load Ipar, DMX ti o dari LED awọn ila, Ina LED Awọn ina Ina Olori awọ ti o ni awọ, ohun elo Ẹmi ti o ni soro Awọn imọlẹ, LED RGB Star Ipa, RGBW LED rin, Led Strop, Led STOLLE, Light Imọlẹ, Imọlẹ Matte, Odi Fidio, LED Iboju, ita gbangba ni ita gbangba, awọn ina ile, DMX Light Giyari, yiyalo yiyalo ilẹ, eyiti o ṣe daradara pẹlu ipese agbara ti o tumọ si oludari, awọn apanirun 8, awọn ọna 16, ati oludari 16 duro.
Ọja Isori : Awọn ẹya ẹrọ LED > Ipese Agbara mabaipo
Atokun Iwadi (0) 
Ṣayẹwo lati bẹwo
